Hi folks,
Got a call for a client who's getting smeared scans on a dr7580 after changing the rollers. Can post example if needed. Smear marks are about 2inches along the length of the page, just...
Type: Posts; User: northernlife
Hi folks,
Got a call for a client who's getting smeared scans on a dr7580 after changing the rollers. Can post example if needed. Smear marks are about 2inches along the length of the page, just...
you can't get into service mode with add functions > 2+8 > add functions?
If that doesn't work then service mode > Copier > Counter > drbl1 > wst-tnr select and hit C to clear. I have a lot of the 3380's that the waste toner counter doesn't clear upon replacement of the...
That using a hot blower or lighter really quick trick actually somewhat works. Was able to buy time on a 6055 call this morning with it.
clean the itb patch sensor real well and run an auto color mismatch followed by a full auto grad adjustments
If the entire film has been replaced and still getting an e000 I've seen relay 1 on the main ps pcb no longer function. It is triggered by 5V from the dcon.
Dirty optics, then run shading correction. clean the light rod with a rag with alcohol as well as the glass, underneath the df glass as well as there's a white plate under there that it takes a...
um, cups comes with all canon drivers except the presses. sudo apt-get install cups then run the cups config.
Mirror image? As in ghosting or the image is 180 degrees out of wack?
add functions > 2+8 > add functions > Copier > Function > Clear > Select ERR and hit ok a couple times for good measure, reboot machine.
edit : May be menu, 2, 8, menu to get into service mode....
Gotta try the adjustments before you change parts though. I'm assuming most of you guys have to deal with metrics and all that other bullshit that's a sign of a dying company.
It's part of the install process on EVERY canon I've ever installed.
Yes, you need do a calibration on the feeder as the values are going to be out if it's not detecting paper properly.
sm> Feeder > Function > Tray-* All four, need to adjust guide in feeder to...
I can't show you screeners due to confidentiality issues but this is the same setup that works all the time for me.
This solution only supports Canon devices equipped with network port number ...
Don't forget to update firmware to latest via CDS if teckat's tips don't work
If you copy a LTR sized page it orientates properly? Are you originals curled? There's sensor flags (White spring loaded doodads) that determine what size original is being fed. If they are broken...
Did you do a full initialization of the developing unit? Toner stirs and all that jazz??
1001 jam code is occurring when running multiple copy and print jobs. However, the jam does
not occur when running single copies or prints. Paper seems to stop before the swing guide
assembly....
I gotta ask but the dial is corresponding to the correct paper size in the tray yes? LTR-R if set to LTR will jam just about the fuser area with a size ng code
replaced the entire fixing unit if not then change the fixing motor. e808 is generally bad connection to the fuser, check pinouts, check pin to pin for continuity, that one will probably be a tie...
1. Check rotation of the Hopper Motor Gear. (If it is rotating, the
sensor may not be detecting correctly. In that case, execute Service
Mode>CLEAR>ENGIN>TNRINST to supply toner to the Developing...
vl1m indicated the measurement taken of the light are potential for copying. (reference only)
Long mode originals will not work in duplex, fyi
oh and they decided to glue the shit out of the ide cable. You will need an oem hdd to get this puppy going. I believe these are encrypted disks and you cannot do the .ini trick to get it to write to...
You can tie authentication to an active directory which will be a lot easier to propogate changes.