Can you swap drum and charging corona for magenta another color
regards
Type: Posts; User: gurko_gg
Can you swap drum and charging corona for magenta another color
regards
Can u share photo about problem
regards
Hello
Did you check thermistor
they re might be deformed.
regards
gürkan
Hello did you clean developing unit and toner filter assy?
regards
Hello,
remove the drum k and clean surface erase lamp.
regards
Hello
did you try reload firmware with isw?
İ dont think so dont burned any component
if you remove before adu card cover, and not firmly replace that cover.
on this condition bypass lift motor gear and opposite gear not firmly seated.
...
Hi,
If Lower roller thermostat blow out On 6500 engine, machine not any error code and still warming up mode.
On 7000 engine solved this bug and machine give error code mean heat time out.
...
Hello
it seems like blowout lower roller thermostat
Hello
İt seemslike bad huminity envoirment.
Enter the serv mode
proc adj
Check the bias value on magenta
if value 0, enter -2
and execute gamma auto adj
Hi
Did you check ground voltage on the power socket
ist not be much thank 1.5v regards
Hello,
Check the 2nd transferbelt unit for correctly plugged to its place.
Regards.
Gürkan.
Hello,
Can you try ADU drive board?
Change the dipSW 11-7 to on. You will be see jam code when change this dipSW.
Plase Let us jam code
Regards.
You have distance problem between drum and developing unit. Make the following steps for countermeasure;
1. Remove K dev unit and clean them.
2. You will see two yellow whell.
3. Paste orange tape...
Hi,
I have 117 bhc6000,6500,7000,70hc model machined in the field.
I saw that problem on the c6000. I asked modelfor that.
Records
Gürkan
What is machines model?
i think c6000
regards
Gürkan
Hello,
Km and dev brands use diffirent toner hopper head.
Regards
Gürkan.
Hi,
do you check adu control wirings for damage ?
I solved problem changing adu control wirings.
Regards,
Gürkan.
Hello
You can change just faulty ph unit.
KM says you should change as a set because registration can be missalign.
Regards
Gürkan.
Hello,
did you clean transfer belt with alcohol or etc?
Gürkan.
Hello,
I mean you swapped Drum Units between color or machines.
bizhub 6000 series machines record the DrumUnit's rotation speed.
If you swapped drum unit you should reset drum rotation...
did you write to service form :D
Regards
Gürkan.
hello
ithink you changed drum's slot
power on while pressing utility/counter key
process adj > initial drum rotation
i hope help to u
regards.
Hello
it seems like magenta drum unit
check the drum surface for deformation.
if you cant see anything check the developing roller.
regards
that's might be bad adjustment value..
you should be first recall standard data into process adjustment menü before anything do
and check the paper process adj values from paper settings menu.
...