Thank you!
Type: Posts; User: Dan J
Thank you!
Does anyone have firmware for this machine? Please send to tcook@aoeinc.com
It was the CCD PCB (u) that fixed our customers.
We are having the same issue. It is getting old fast!!! Some of our customers are over an hour away so it cost us money to send technicians out to reboot machines or get meter reads.
Looking for an easy way to copy the address book from older machines to new. 917 works for newer to new. We have tried net viewer but it has been failing almost all the time.
Has anyone tried the Chinese charge rollers and if so do they work?
Replace or clean the charge rollers.
Had a similar problem recently, except that single sided from any source was fine, 2 sided - second side looked like your sample
(very washed out). Ended up being the EEPROM on the engine board....
We have a few.
I suspect this points to at least part of your problem. If you're getting a reply from the ping, you may have another device with the same ip. Remember also that since you changed a router, the...
I've never seen this problem on a 2550, but in the past this scenario has always involved the optics ribbon cable. Particularly where it flexes as the mirrors move. Maybe even the inverter PCB.
Manual says C0220 could be Main or Operation PWB. From experience, it could also be the chips on the main or engine PWB's. When you order a board, it doesn't come with the chips, so it's probably a...
No, they're not the same. KM-1815 main board is 2DD68030. KM-1820 is 302GM01380. The number you listed, 302GM01410, is the KM-1820 Engine board. The KM-1815 Engine Board is 2DD68040.
Cool. I'm going to mark that error code down for future reference. We all have those man made errors from time to time!!
No, you can't swap fusers, but the error you're getting is for the image formation unit (drum unit). Didyou have the drum out?
The codes in the maual start at C011. I don't see C004. Are you sure that's the number?
Also, make sure the customer is loading the paper properly. If the bottom of the stack gets curled, the tray won't lift correctly.
Not to step on anyone's toes, but the part numbers are 3BC07010 and 3BC07020.
I sure wish I would have seen this post last week! Tha color dv motor not turning, but 7101 (black) error. Of course I tried everything else first, but the K DV fixed it.
After you take out the 5 screws, there are 2 gray latches that have to be released at about the center of each side. But before that, you'll have to pop out the cover above the waste bottle and...
Most likely have to replace the whole drum unit.
Thanks!!
We're a Kyocera dealer, and one of our customers has a 2018d they want serviced. I can't figure out how to remove the drum from the drum unit!! Is this a very difficult job, or am I just missing...
Press Menu on control panel, scroll up or down to service, scroll over ( > ), scroll up or down to maintenance, press enter twice.
Hope that helps!
Check the separation roller and spring in the cassette. You might even need to stretch the spring a little.