Take a look at this:
Type: Posts; User: Hose1cook
Take a look at this:
Take a look at this:
It's a Mono machine, no Developer. If he didn't run Sim 130 the developer tank is probably not completely full of toner. Could be the old style charger in that kit which causes a similar issue.
Look at the link provided above, there is a photo of the main board with the SSD pointed out.
There is no dial on these machines, are you sure you don't mean the M3540?
According to the book Bill and Dave (Hewlett and Packard) in 1983 Canon wanted to find a partner company to sell the first Canon Laser Printer, the LBP-CX, a few companies turned them down until HP...
Usually this problem is caused by the plate that lifts the paper, it's spring loaded and the L shaped catch that is on the bottom of the plate gets bent and will not release to lift the paper when...
Have you confirmed it does not do it when you put the original on the glass? If not I would use the charts ( U411) to get it back in spec.
1) That is the right part
2) It's installed after the machine is placed on the PF-740-see attached
44055
I would sell them the CS-3212, has everything you are looking for and is a good machine for that volume. CS-4003i is even better but the deals on the 3212's right now can't be beat. If you're in...
USN 1971-1973 Torpedo Technician USS LY Spear AS-36 (Sub Tender)
Apology accepted.
I've been called a dick before but that's rather extreme, and nasty.
Right out of the 3050/4050/5050 Parts Manual, they will fit all the machines you mentioned, along with Falcon 1,2,(3) & 4 and the 1620,1650,2020,2050 ,2550 series.
2AR07220 PULLEY,PAPER FEED ...
I have a few doing this, one I just set up today. Is there any documentation? I just searched the QA's and nothing came up. Thanks.
Just found this:41708
I have one in the shop right now, same problem, although I could not get 2 copies in a row without a jam in the registration area or fuser. Doctors office 45K on it. 501,4201,4211, 4219 jams. Turned...
Maybe someone is sniffing it to get high...........
Yes, I have replaced one for the same problem you describe.
Swapped the Y & K LSU and machine worked, but before I put the covers back on prior to turning it on I noticed the Duct Cover and Duct Holder weren't closed properly. I opened them up and closed them...
Thanks, the Y laser is the one I replaced initially about a month ago, so if it's bad again then either the part was defective from Kyocera or something is causing it to fail. I agree that Kyocera...
About a month ago this machine was locked up with a C4204 (BD steady-state error Y) but the customer had said they were getting C4202 (BD steady-state error C) codes before it locked up. I replaced...
Machine has 214,187 copies on it, 188,040 Color and 24,890 B&W. The MK-8325A was done at 203K. The problem they are having is streaks of magenta on most but not all of the prints/copies. I have...
Sim 159 > set the "Container Unlock Display" to on then open it in adjustment / maintenance in the system menu. Don't forget to turn it off if you don't want your customers to change toner...