It installed the new software and the problem solved. Grateful
Type: Posts; User: megacopiadoras
It installed the new software and the problem solved. Grateful
The machine to connect displays this message in the picture below, or asks to resume it, restart it, but back to the message, it does nothing and does not release any button.
32795
the message...
The drawer 1 recognizes the panel to A4.
But the machine does not release copy it because the paper does not rise.
What did I do:
I did the dc-con and nothing
I cleaned the sensors and...
GREETINGS,
IN DRAWER 1 OF iR5075 WHEN CLOSING THE DRAWER PAPER NOT MOVE UP
WAS EXCHANGED THE ENGINE OF THE DRAWER AND CLEAN THE SENSORS, BUT
THE PROBLEM PERSISTS
Staff speaks, I have a ir6570, and it presents the following problem:
When you take copy A4R copying out with the crumpled end,
more only when the machine plays the roles with the image down.
...
Both windows are clean, the band only appears on one side of the copies.
When 2 for 2, it always appears on the first page in the second not.
I tried using the DC608 plus it gives error.
My Xerox wc 5875, presents a black bar at the top edge hen is only used the document feeder,
the glass does not!
how do ajsute feeder.
The document size is A4,
I do not have her manual!
...
Staff now iR5075 when shooting copies Duplex by RADF she curls up on the PCB 2, and the original gives a folded, only duplex in normal copy it does not give problem. Jaz fi all procedures RADF...
è seems that the problem is actually in PC3, he gives inverted signal, weird huh?
I'll exchange it and then post if it worked. more almost 100% sure.
Thank you
è parece que realmente o problema é no PC3 , ele dá sinal invertido, estranho né?
Vou trocá-lo e depois posto se deu certo. mais quase 100% de certeza.
Obrigado
Do the same RCON DF-tester with the RADF in othe machine and had the same code?
Good morning friends! I have a canon ir 5075 presenting the code in the RADF jam soon as I start a copy of the RADF, I noticed that the code is 0094, cleaned all sensors on and did SENS INT,
...
already solved the problem really was the dc plate dcontroller, thanks to everyone who lost a little time.
I never do that, would be more appropriate, since it already testing the fan and even this ok?
I put the DC Controller this machine that has the code on another machine, and the code presented in another machine also.
Will DC CONTROLLER.
I have a IR6570 and when I turn on the machine it shows the code E000121-001, have changed the FM4 fan controller and still the same problem. When I check the voltage on the cable 10V FM4 time comes...
hello friends, I have a canon ir6570, that when put in dadf A4R 10 original and one copy of each shot, the copies are wrinkled at the end of them. I realize that the copies are the duplex tray to...