Search:

Hey folks, got a nifty one for ya, we have several of these machines out in the field, and now 2 of them are giving a cryptic "Lamp Warning."

We've googled, we've search the Lexmark knowledgebase...

Another option I have had success with us to swap the connector board at the back of the drum unit. Though I wouldn't advise doing this if you are trying to put a 3050 unit into a 4050 or 5050 as the...

Only mispunch I've seen regularly on that finisher tends to stem from either the chad's getting jammed up in the punch unit, or the punch heads having burrs on them, both of which cause the punch...

Forgive my ignorance, but where exactly did you find this bulletin? I can find no trace of it on SSAP.

Sorry, wasn't very clear on that one, what I meant was that the LCDC on the machine is newer than Jan 2010's production date, which is referenced in the bulletin (33) for the LCDC firmware/fuse...

Unable to access the web page, and I've tried the shining a light on the display, but I can't see anything. I'm checking the resistor discussed in MPC 3300 Dead Display panel - Ricoh, Savin,...

I have an MP C2050 where the op panel appears dead (though I get some reaction from the soft power button) the scanner carriage does it's initialization check and the fuser is coming on, but the...

Check to make sure the spring on the drive arm that connects the exit unit to the drive gears on the door is attached, it's only held on there by gravity and the slightest bit of tension, so it's...

The problem only occurs from tray 1,on both prints and copies.

I have swapped rollers & torque limiter. I have cleaned and the swapped clutch with the bypass clutch. I have tried multiple paper sizes, orientations and levels. The machine consistently feeds the...

Hey folks, after much gnashing of teeth, I discovered that the machine was set to default to stapling via the web page. Once I turned that off, everything worked fine. It appears that, while the...

Thanks guys, I'll give both ideas a shot.

Hey all, this one is making me a bit mental. I've got a customer with a MX5001N, with a saddle stitch finisher and a bunch of new Macs. The machine has PS installed, and we've loaded the latest OSX...

Oh wow, I can't believe I mixed that up. Just couldn't seem to get my brain to fully engage yesterday, might be a lack of coffee. Thanks again, the part has been ordered.

Hey, just a few questions, you refer to the roller 302FB19401, which is the switchback roller, and yet you give mesurements of 66 - 64mm, which don't make sense. I could see if you were talking...

I have indeed, was the first thing I did after he said I'd need a board.

I just got off the phone with Sharp Tech Support, I checked all the fan connections, and had already replaced the Radiate Fan with a new one. The chap at Tech support indicated the same fan you...

Thank you for the speedy response, I've swapped both of the fans in that section with the one from section 63, and I'm still getting the code, my next step is going to be tracing the connections all...

I'm getting the same code, I've checked all the fans in sim 6-2, and all fans are spinning nicely. I'd love to just swap the fan, but seeing as there is no "fuser suction fan" in the parts manual,...

Did you ever get a working solution for this, from what I can tell the FRPO R1 has been removed from most of the newer Kyocera models (falcon 3+ for copiers, and apparently sometime before the...

This post right here is exactly what I've been looking for, you sir, have now been a Godsend to me. Thank you very much.