I have an accountant that needs to copy checks, that they are depositing
copies reg checks and everything just fine.
but the checks with the silver foil box.. display says protected document...
Type: Posts; User: Tec1
I have an accountant that needs to copy checks, that they are depositing
copies reg checks and everything just fine.
but the checks with the silver foil box.. display says protected document...
I had a diff model the other day lock up when printing from newer PDF's
other workstations with same config could print no problem
switched that one workstation to open PDF's with foxit instead...
not familar with this particular model...
check vertical clutch, clutch that is right before timming clutch.
machines should have alittle buckle between the two clutches, but if vertical...
KM Bizhub C352
did you ever figure out how to get rid of open door signal, when removing the SD-503?
I have a customer that wants it removed and having same problem.
not finding SD-503 installation guide
like above post, even tho reinitalized hard drive..
make sure machine knows hard drive is installed
i think you can only chip the 200.
not the 250
must be C2557 IU prob.
i'd just replace the unit.
i've just been putting in the Di350 IU ( have to cut notch out in upper section and remove drum shutter maybe modify pins the key units)...
yes i mean the belt that drives the print head assembly
haven't seen 5035, but prob like all the others. check swing plate assemby gear (fuser drive assemby) prob has a pile of gear dust by it
haven't worked on that model, but have seen on large format if scanner belt is not in the right postion, it will say to replace various print heads???
OEM toners?
replace both clutches in there, since you have it all apart
i just modify Di350 IU
then drum, develper unit and developer are replaced all at once
i have a customer with a CS 2050 and they use their manual feed tray alot.
i have had 3 calls, maybe 10K - 20K between calls for this problem, manual feed won't feed.
signal switches at board, i...
when you can snatch the pebble from the hand, before the hand closes
they should put in new chip when remanufacturing it
you can save some money if you get a catridge with just toner refilled (A load and not the X load)
do they put in new drum, drum blade, doc...
B4 i wuz att skool i koo didnt speel tecneetion
Now i is one
4100 has a chip in the middle, front section of cartridge. if it wasn't replaced (if a comp cart) then machinr won't know it is a new cartridge.
otherwise should be able to hit green go button, to...
try man handeling that tray assembly down a bit, then turn back on machine
try old HP driver, just to test if it prints???
i like them
they are getting older
and as previous post said, adf has had some issues
i believe left side lower cover needs to be popped off with little tweeker.
little holes in cover, put in driver and turn alittle
note: sometimes you break tabs to get cover/covers off on some...
take off all covers and control panel
then you will see how glass comes off
also, try unchecking SNMP in port config.
sorry, forgot to mention that in last post