Search:

Mine is not exactly the same, but yours is the closest post I've found to this problem:
I have an HP E82560 Laserjet, on duplex copies the second side is much DARKER. I've seen no referrence in the...

I've got a couple of M6535cidn in a very dusty warehouse with the same problem. I've unplugged the cleaning motors on both, which got rid of the codes, but I have to manually clean them every few...

Searc
hed kda download center, can't find...???

I've seen that too.
You might try taking the copies you just made, now dried out by the heat of the process, and put them back in the paper tray, face down.
If they don't stream this time, you know...

Yep! My first service call on a TaskAlfa 6052ci today was for a mystery squeak. Customer said it is loudest in the morning when it's cold, but I never heard it. Did get some pretty good...

I've seen a couple of Task Alfa color machines (4550ci, 5550ci) where the ITB is leaving grey or colored smudges on the back of copies, especially on the first 2" there will be a yellowish grey bar....

I've got a used 3M. The power cord port needs to be replaced, but it still works OK.

Interested?

I've got a Task Alfa 8000i with a (PF-770?) side deck that intermittently gets stuck at the upper limit. Customer cannot open to refill paper because the lift stays at the top. I have previously...

Yep, I'm getting the same symptom on a 3500i with DP-700 not lifting. I cleaned out all the dust and paper clips (of course) but the lift motor just seems to stall sporadically. Even more...

I'm back to an old issue that has not showed up in months: I thought I had it fixed, but it turns out they just haven't been using it much...

A Savin 9060 (Lanier LD360, Ricoh MP6001) on which...

Yep Yakyitz is not dreaming this one up! I have the exact same message on a 5501i that just passed 300K: "Time for Maintenance" message, (preceded by a wrench symbol) NO letters "A" "T" or...

OK, so hang me for a Fool! The copies it was making DID look ALOT better than the prints, but my Super took a look and said that he could see the uneven density on the copies too. (Ha!, "Sure", says...

OK. Months later this 6500i is still doing the same thing: dark on rear frame, light on front.
HOWEVER: I think I can see the same thing happening on copies too, it's just MUCH less noticeable. ...

089 prints are same as status pages: faded at bottom. I'll go back and try to pin point the problem...
...and yes,I know it makes no sense!
Thank you.

Yes, it's just the way I said: faded prints, good copies. I'll try cleaning ducts, thanks.

I've got a Task Alfa 6500i that is producing printed pages with faded image at the front frame edge (approx. 2" wide). Copy images are fine, fading only occurs when printing from PC or printing...

So hey, I'm an old-timer to copiers, but new to this website/group, and also new to connectivity in a manner of speaking. My company is beginning to push for more knowledge-ability in connectivity...

Thanks BlackCat. I went back today and cleaned all four gate solenoids on that DF-760. That seems to have fixed the J-85. At the same time, I found the pin had fallen out of the torque limiter on...

Test reply...

I've got a Task Alfa 420i with a DF-760 (3000 sheet finisher) getting a Jam 85 exiting to the sub tray. I've already got the customer to put thick plywood under machine and finisher. Any...

I have only one Savin 9050 in my territory, and don't care much for it: always getting spotty, or light or dark or some such. Today I replaced the developer again and the mag roller was black with...