Dear all
I have a customer forget admin password on sharp mx-c300w
How I can retrieve it or reset it to default password
Type: Posts; User: swagreis
Dear all
I have a customer forget admin password on sharp mx-c300w
How I can retrieve it or reset it to default password
Just trying with mx-5000n
Sent from my SM-N9005 using Tapatalk
I changed primary transfer belt
Sent from my SM-N9005 using Tapatalk
I changed primary transfer belt
Sent from my SM-N9005 using Tapatalk
Which drum may cause this error
This sensor in drum unit or in machine
Thank uhttps://uploads.tapatalk-cdn.com/20190114/820a4178daa5b1b4292695461a83d6ed.jpg
Sent from my SM-N9005 using Tapatalk
I have an error message on simulation 50-22
"Sensor calibration error fr-06"
Pls advise what to do
The color can be seen each color alone
Many times the machine late in copy or print and give this code
I know this hard disk fail
It must be changed or not?
If yes what is the steps taken to change hard disk
If no what steps to...
It is not a software problem because in the same driver when changing the port to TCP/IP it prints else nothing happened
I upgrade it and change usb cable quality to shielded one but I have the same result
I faced a lot of times when connecting MX-354N series as local printer using usb port it works good for a while may be days and then fail coming on and it does not print any more .
It works only in...
Dear all this is my first time to connect PAPER CUT software with MX-464N
What is the procedure to connect PAPER CUT with this model
Can any advise me how to do it?
Thanks for your attention
Dear all this is my first time to connect PAPER CUT software with MX-464
What is the procedure to connect PAPER CUT with this model
Can any advise me how to do it?
Thanks for your attention
Message exactly
Phase cyan error 121
I did all above but also the same!
I changed transfer belt unit but no change
U mean to readjust program 61-4
When connecting this model as usb printer after couple of months usb port in MFP becomes fail and no sense between computer and MFP I changed the whole MFP board it works again but after couple of...
I have a trouble in this model that when I made b/w copy it is good but when made a color copy it gives also b/w copy low quality and also in the beginning of this trouble it sometimes gives color...
U mean IP of computers that scans going to
If yes give static IP's to computers
So it may be from cables and connectors of machine may there is a bad connector pin or a wire
Try to get a machine frame from a scarp machine
Try to change MFP first may it is
If not change power board
I think one of them is the defect item
What do u mean?
Look at paper tray setting at LCC u will find that print function in not marked
First be sure that dev code 312
This error means that dev. Decreased in dev box so we have to search about the reason why dev decreased in dev box
It will be dropped in machine or u find it waste...
Thanks I will