Can anyone tell me what is sc 547.i know its a fuser error but cannot remember if it is a fuse and if u know part number.
Type: Posts; User: hodgiepodgie
Can anyone tell me what is sc 547.i know its a fuser error but cannot remember if it is a fuse and if u know part number.
ipu is the proper one
there is no hdd.
REBOOT
Right, relay clutche
THEROSTAT ALSO
also r mem chip w/ 124mb,no change.
MULTIPLE SC 193 ERRORS,REPLACED ( IPU BOARD) .NO CHANGE.PLEASE DONT TELL ME GO TO NEXT BOARD .(CONTROLLER OR VIDEO CONTROLLER).:confused:
:o debris covering connector to fuser...thus the mouse inc the copier.no lie...
Error message sc - 569 replcd sensor and harness. THEN I GET SC-550 AFTER RESETING THE SC-569. WHAT THE HECK....
me too stupid error on my part
ribbon connector from optics loose . problem solved.thnx
performed 19 scan disk. also had boards out for adf .
no finisher to copier
Connectors on adf . Chk all accs connectors
canon wont go to ready.fuser heats up no error message . stays at please wait .:mad:
need to cross reference LD 260c. LD 435c LD 520c. lanier to ricoh. SERVICE MANUALS WOULD BE NICE TOO.
hmmmm well how about the acutator arm.then i guess we would go to clutches (clean w/ alcohol).then feed station
hey give the guy the fuser exit sensor part number already.i thnk its fuser exit sensor.will look it up asap
well service mode to replace image transfer belt. i am trained on the nec 25c5.when i tried to get into service mode the copier sked for password.
how do i get into service mode and or reset password.is it same as nec 25c5 copier.how can i obtain a crossover chart for nec .bizhub etc
well i feel i have done all that so i guess i will have to call ricoh
ok im confused.can you give me a step by step.i have tried all the settings and am still not able to account for print jobs or get the desktop computers to ask for user codes.could the problem be...
yep pick off pawls .i usually blow em off w/canned air.see if they show up when using finisher,i noticed them more when using internal tray'.stupid desighn.
set print to inhibit in user tools .can you tell me where that setting is exactly.