We had success by setting A to zero, and C to 10. Leave B at default.
Type: Posts; User: DavePo
We had success by setting A to zero, and C to 10. Leave B at default.
Have you verified that you are getting 24VDC at the switch? If missing you would get that message.
We have had that for 5-10 years now. Sharp says no problems. I usually threw them in a microwave for about ten seconds warmed them up enough to stay put.
It appears that they are the same.
Looks a lot like a Laser Unit issue with the black beam.
Fixed both machines with the message by also downgrading firmware. Have 1 stapler that is bad however, now doesn't recognize staple present. Awaiting replacement.
I have it also on 2 7002i's with DF7110. Hotline wasn't helpful. Ordering staple unit and finisher control pwb.
What is the humidity level reading in TC 44-14? We had one last year in January that did this exact thing. The Humidity in the room was less than 10%. When humidity gets that low machine can't...
Check the connector in the rear frame that toner plugs into. They can be bent out of position.
We had one that the safety latch for the Doc Feeder was broken. It is needed to keep adf from opening when toner door is lifted. The latch is in front left corner and actuates a latch in front left...
System Settings - Image send Settings - Enable/Disable Settings check if anything disabled.
Have had a magenta developer unit, a yellow developer unit and a black developer unit fail. The magenta happened at initial power up, a seal was pulled out of developer unit and into drum unit. The...
Another thing to ponder. We have had several 2300 2700 3501 and 4501 machines develop the f2-6X error. Upon investigation we started to see that the toner motor would run backwards every other time...
I use a magnet out of a old HDD. Put it in a pouch behind my screwdriver and every time I put it away and remove it gets magnetized.
We are having same issue FPDD_S jams when trying to staple. Sharp said try sensors (have replaced all no help). Try greasing rail for stapler no help. Have replaced board also still same issue....
Not to hijack the thread or change subject, I swear by Rain X Bug Remover Washer Fluid for summer driving. Doesn't completely get rid of all of the mess but it's better than anything else out there...
Neo your where on the ball. The problem was one of the pins in socket was bent. Another issue was that HTTP protocol was turned off. Straightened pin and enabled HTTP and all is good.
My issue is that i am not showing any link on the switch and status page shows no connection also. This is either dhcp or static.
Have a new FS-2100DN fresh out of box, when plugged into network doesn't show any network connection. Status page shows under current LAN interface not connected. Have tried different cables and...
Found issue to be under User Control, Card Type/Card Reader Settings. The check box Use IC Card for Authentication needs to be checked.
Anyone out there using PCounter software with Sharp MXM365N imagers? If so are you using a external card reader? Any problems? We have installed four in recent weeks all have issues with reading...
I agree completely, I believe also that Sharp sees this as a large loss of revenue. Cant tell you how many times customers have bought new machines and added the new license to their existing license...
Mine is not a Kitchen top toy. Though I love to cook with it. My Smoker and Grill.
First post and wants password?
Cause:
Drum phase sensor trouble.
Harness and connector connection trouble.
Drum drive section trouble.
PCU PWB trouble.
Check & Remedy:
Use SIM30-1 to check the operation of "DHPD_C",...