Search:

Have to ask is it worth all the hassle, fix it in place, if customer wants a new cassette sell them a new machine!!!

Don't know if you can replace them as usually the plastic locating ping breaks off, best solution is screw the guides into a fixed position or replace the complete cassette if you can find a good one.

Sounds like the SD Ram is faulty
would try replacing memory dims
Dimm 833W39035 2GB

Dimm 833W39041 1GB

It is usually the patch sensor is dirty, very common issue on this range, if you remove the black toner cartridge, you can get access to clean it in the machine, reach in open shutter and wipe the...

I would suspect it does not, if similar to other Fuji boxes, the only solution is to use something like smtp2go.com with what ever email address you want it to send from.

Found this in searchlite

After replacing ESS NVM, FC 117-325 displayed (after serial number sync). The fault cannot be cleared by any action (see ET 1256824).A second NVM has the same problem! In...

Sounds like ITB cleaner, had ITB cleaner blade flip often, in most cases had to replace both ITB and cleaner assy

Did you change the smtp port in service mode lvl2?

I suspect it is down to security/encryption methods used by copier, not deemed to be as safe/secure as from pc's, not much you can do apart from use port 587

Have you tried changing to a gmail account on port 587? or you could use something like smtp2go on port 2525 with no encryption if you want to keep same sending address

Yes clear the error and reboot if that fails get the screwdriver out!

Canon Open toner door on iRC ADV
*28* level 2 - COPIER- OPTION- DSP-SW - T-CRG-SW set this to one.
Then thru customer setting (star head) ADJUST/Maintenance - Maintenance - Replace Specified Toner

Don't know if you are sorted yet but worth switching off Multicast Discovery under network settings, had this cause strange issues
36958

I would check the IBT assy dirt on the rollers under the belt may be you issue

what about setting up with a gmail account or smtp2go, something like that if it sends ok with that it has to be down to office365 setup.

Have you tried setting encryption on to TLS or STARTTLS rather than auto?

Try this link for a control panel sim

2016 ConnectKey Technology-enabled MFP User Interface Simulator

or the new Versalink range

VersaLink Simulator

I don't think it is possible on the 71xx range, IP address will show on info screen but unlike 72/75/78xx ranges I don't think you can set it to display on the home screen.

The following modes are enabled by pressing a
combination of keys and turning ON the main power switch, Use these modes when
the system is unable to enter Diag mode due to troubles or to clear...

check HDD has not been removed, if not reload firmware.

You should be able to use a new printer connect with usb cable, let printer install itself as normal, then go into printer properties on the driver and change the driver there to point at what ever...

Yeah the old driver works with most modern/new printers regardless of make, have used it on Canon and Xerox in past

I would try using an old HP LaserJet 4 pcl driver, very basic driver but it may work for you regardless of the printer model.

Which Xerox model are you using?

What firewall is running on the Windows 7 PC?

Port 139 and 445 are the ports SMB uses to send to your PC

See attached screen shot for setup on Xerox device.

In windows firewall under file and printer sharing enable smb for ports 139 and 445

In the share folder you create, make sure the user account you use when setting up the scan templates has full...