In order to increase the fuser temperature, i cut a piece of old film and put it under heating lamp, where the sensor located, but the heat went up and some melted toner appeared on the printed paper...
Type: Posts; User: parsmehregan
In order to increase the fuser temperature, i cut a piece of old film and put it under heating lamp, where the sensor located, but the heat went up and some melted toner appeared on the printed paper...
Could it be due to thermistor failure?
any other idea ?
Hi
As usual for worn and faulty fuser film in hp 2035 & 2055dn, film and press roller has been replaced. but when initializing the printer, as it is obvious in the attached picture, the demo...
Thanks.that's very kind of you
53066
I have just found this briefly service guide on the web!
anything more complete ?
Hi
There are some issues with canon lbp 6780dn printer which need to check the service manual.
I think this model with lbp 6780x are the same.
If anyone could send a link or upload it that would...
Unfortunately I don't have access to the service site.
Thanks anyway
Hi
sharp ar-m450 driver installation in windows 7-32bit has a problem with printer properties. in fact the options are disabled.
This could be because of incompatible driver but I could not find a...
The service Manual for this model could be helpful. If anyone has or knows where could it be downloaded please leave a comment.
HP Color LaserJet Pro M153-M154/MFP M178-M181/M253-M254/MFP...
I've tried to do this before but couldn't find that option in printer panel set up.It should be under Diagnostic,but in that section there is just Fax one.There is no such option in other menus .
...
But why just the yellow cartridge has this issue, the other color and black cartridges has been refilled with the same toner and seem to have no problem with toner quality.
Also The hp printer...
Is that because of high voltage in Yellow Cartridge?
Hi
it's about hp 203A color cartridges for Laserjet M280fdn, which after refilling, demo page prints with entire YELLOW background!
Tried to print configuration pages, first one printed ok with no...
I Just replaced fuser film and serviced whole fusing unit.
It's not about paper path or duplex..
stop test shows that marks creates when paper reaches Registration roller.
Thanks anyway
Yeah i know,but it's not about what prints first in duplex printing, i meant when paper returns through duplex it doesn't feed by pickup roller so it could not be the issue.
I did stop test.
fuser...
Hi
Hp laserjet 2055d leaves two black marks on the back of the printed paper. The marks repeat in duplex printing (picture) but the distance between the marks are different .It seems as if the...
Well. if C451 has no animation guide,what is the message appears on the panel!
This website seems to me and some other ones as a place to help other technicians,and receive guide from them, not a...
Just looking to find a way for that files!
Konica minolta strategy in supporting unregistered Service Tech is not that fine!
seems nobody has Tech ID in this forum!
Yeah,Tech ID .that's the matter
Inbox Seems to be limited ,cause there are only few mails in it.
The email is Parsmehregan.co@gmail.com
Thanks
The issue is about your workstation, windows 10 , which you should enable SMB function through this pass:
control panel-> programs->Turn windows features on or off
then make a check mark on SMBv1...
Hi,
showing "no animation.." message on the main panel make question for many clients , so I need bizhub movie data file for animation guide in C451, 452, 454 model.
unfortunately I don't have...
@copyman @blackcat4866
As mentioned before local network has no problem, even I changed MFP's IP address for sure.It could be pinged from both sides. probably HDD should be the issue...
there was a problem with fuser which need to be fixed.
except that, machine was working fine.