Document Imaging Partners is a growing company in search of a qualified technician to work on Kyocera MFP's.
The ideal candidate should also have experience in setting up the copier on the new...
Type: Posts; User: Estico
Document Imaging Partners is a growing company in search of a qualified technician to work on Kyocera MFP's.
The ideal candidate should also have experience in setting up the copier on the new...
wondering if you got this fixed... I have a C7942 error on a TA-4551ci. Thanks.
Kyocera Service Technician NEEDED - Kitchener/Waterloo area.
Send Resume to:
Marius Apostol - mapostol@docpartners.ca
ehe, vremuri vechi dar bune...
din cate stiu... ei au ramas pe Xerox chiar si pe meleaguri canadiene.
cam asa ceva... salutare tuturor!
Kyocera Service Technician NEEDED - Mississauga/Toronto area.
Send Resume to:
Marius Apostol - mapostol@docpartners.ca
we have one doing the same thing. i have asked a kyocera rep to have a look at it. will keep you posted.
We are in Breslau, Ontario.
LOOKING FOR TECHNICIAN
Document Imaging Partners is a growing Office Solutions company located in Breslau, Ontario selling and supporting Kyocera MFP's.
We have an immediate opening for a self...
Will do. Thanks for the tip.
Looking for experienced Kyocera technician to start immediately.
We fixed it today - the board interface where the color drums and devs connects was causing the faulty ground issue (blue marks on prints). Thanks everyone!
I checked the high voltage and bias values -everything looks normal. We’ll go back tomorrow and take it apart…
yep - i replaced the cyan drum unit assembly, cyan dev and transfer belt. Also swapped out with Yellow drum (which includes the main charger) - same result.
the original call was for blue dots - replaced cyan drum then got no cyan on color belt U089 - only the blue marks... After that we tried new cyan drum, dev and transfer belt - no result.
just replaced Cyan Drum, Dev and Transfer Belt - same result! Any idea? Thanks.
is it only jamming when feeding from tray 3, right? if yes, here is what you need to do - double the springs on the bottom left cover (from vertical conveying unit)
the lamp goes on when power on... Any other thoughts? Thanks again.
The controller is working fine, i can print to it no problem... It is the scanner not working and because of the "initialization fail" error can't really get into service mode.
i have the service manual but there is no code on the screen so not sure what to look for...
initialization fail with no error code - does anyone know what is the issue? thanks.