Use Rubber Re-Nu. Doesn't dry out and cleans perfectly.
Type: Posts; User: daveh12
Use Rubber Re-Nu. Doesn't dry out and cleans perfectly.
Looks like a horrible job to do for something so flimsy. Thanks for pointing out this issue. Hope I never see it.
Agree with this, very common on this model.
There is a drum blade that sits in front of the drum unit, its comes as part of the maintenance kit, it can become stuffed with paper dust and residual toner. has this been replaced or cleaned out?
Check that the speed settings match the switch port i.e. duplex 100 mbps. Can change in the system settings. this can cause the copier to drop off the network randomly.
Connections are solid and copper connectors were replaced. No change.
Apologies for the slow reply. One of those weeks. Yes this was replaced with both copper connectors but the issue remained.
Hi all,
Any help with this issue is greatly appreciated. The above machine constantly codes out to the code listed. Recycling the power clears the error until you run another job and after the last...
Km3050 Drum wont work on a 520i, but a KM5050 drum works just fine. and vice versa
run AC Calibration in U464 everytime you visit these machines to avoid this exact issue. if you run it now after checking the magenta unit it should be fine. no need to replace. what count is on the...
as said above yes it repairable.comes out from the back. pain to remove though.
I know they have updated the developer units for these machines because they caused issues that look suspiciously close to what you've shown in this picture. ive replaced many, some with with only...
generic toner is the issue here 100%. after a toner change the quality of prints goes downhill fast, dirty grey background etc. then you have to hoover out the developer and fill it again. not worth...
The Dev Units in these machines are notoriously bad. Check the count on this part, its life is 300K (which it rarely gets to). if its anywhere around that replace it. Also clean laser glass from the...
Images would definitely help here
Agreed. If its not doing the engine update then why bother.
Stick to what you know so. Thanks for the replies everyone
exactly , vacuum is definitely the first thing to do and chances are if will solve the issue. If not then toner pump next
Hi,
just wondering what peoples opinions are on updating firmware on Ricoh Models with the Smart Panel through the Application Site App. When it comes to firmware updates i stick to the tried and...
Unfortunately with generic toner you can never rule anything out. I would have a spare toner cartridge, toner pump, developer and drum units on me just in case. Generic toner is unreliable and...
Different yields on the toners for low end machines. Higher yield toners on the high end machines, probably just use similar toner bottles so not filled as much. if the weigh is what it is supposed...
I agree, flashing the firmware is the first port of call before all else, then take it from there.
check the advanced sharing settings on the PC. check the password protected sharing also.
can hoover out those devs if there is any issues with non-OEM toners anyways
These fusers are a joke. Think kyocera are on their fourth or fifth type of heat roller for these with no improvements, still wears or toners build up on them. If you get one that does 600,000 prints...