I have the same issue ..could I have the answer please
Type: Posts; User: SteveF
I have the same issue ..could I have the answer please
Hi .you need to go into factory mode and run
Sp
5-846-46
That should do it
have you tried using rest admin and supervisor password sp on the machine ?
hello
have you tried pressing yellow key followed by pressing 1 then 4 then 3 then red key 3 times holding down on the last time ..
turn machine off then on ..it might turn back on and not asking...
Hi Yes it is possible to load the smart screen firmware onto a normal ops panel machine . Ricoh say it will cause strange op issues ..the firmware 1.21 should be ok
system copy D1495550t v 1.19...
Hi all I am having an issue with E6-11 I have changed both control and PWB boards but still getting E6-11 scan lamp lights on test mode on the dspf but still has code
Anyone have any ideas?
wow I hope you can follow that pdf .... ricoh official way to reset password is to replace nvrams
dose the sc code stay or are you only getting it when trying to update firmware??
if only happening when trying to update can you remote into the machine through wim,, if you can you could try to...
Hi luckerx
you can reset the admin and supervisor passwords without having to replace the nvrams
pm me and I will give you the info ...if you still need it
I have had the exit unit seize up.. just enough to cause this might want to replace it or change bearings
Hi
on that df theiris a cushion stuck on the edge of the duplex gate ( to stop it making a noise ) it becomes sticky and stopps the gate opening on time or opening at all
Hi
Are you useing original toner for this machine or compatible ??
Hi You could try formatting HDD ..defo hard drive issue
has this machine got an lct fitted to it ??
defo 1.0.6
has new 6502 and 3003
print scan option has been merged with another sd card on another machine ..only way around it is to un merge scan print from the machine it came from
turn off ccd for colour paper and paper detection
Nice machine :D
the connectors are part of the drive unit ..luckly i had an old drive unit off a scrap m/c and use the connectors off this ..no other way im affraid ..
The reset fuse is on the sp820 sp811 fusers u use for the mpc4500 etc ..hope this helps
I agree with jisa
Its the rotation time on press roller..
I had the same thing happen..
5502 fusers are a joke we have had 2 go down and had to source blow fuses for them when we rebuild them ..they carnt cope with medium coverage colour (dosent seal toner properly) they jam when they...
Hello
I think you need a hdd fitting .
Print and scan sd card
I think the parts you need are in the service manual under installation ..
Hi Blazer
If you swop nvram from old control board to new one you should be ok ..nvram normally in a plastic case that is clipped into the board..
If when you turn on the machine and the scanlamp...
"FACE PALM" back at ya