its the random white dots not the lighter area , that is just engineers camera
Type: Posts; User: big jase
its the random white dots not the lighter area , that is just engineers camera
PCQ, we have replaced drum and dev unit but still have this issue56505
has any one seen this before
It turned out to be the TLS setting needed to be on 1.0
The embedded terminal installed absolutely fine and looks as you would expect. The issue is when you try to log in. It will try for a few moments and then it says that itThe embedded terminal...
Hi
Strange one, jams 72-19 in finisher but only when doing a double-sided job and only when a full darker print is on the 2nd side
C1085 , grey background on all prints. Swapped charge grids drums ran gamma setting but still the same46967
C1085 , grey background on all prints. Swapped charge grids drums ran gamma setting but still the same46967
Yes but get code on closing doors , get no drive.
The model is C1100
C1100. C3103 code. 2nd transfer not lifting
Checked all gears cleaned sensors no joy. Just codes up straight away. Any PPD guys out there who could point me in the right direction
Was getting...
Hi Synthohol
could you send me those links to system software please. My Customer has lost them!!
Thats was my initial thought but i would have expected a line caused by laser would be in the feed direction
Hi
I have a 2551ci with delation lines in the cross direction, only appearing on Magenta & Cyan. we have tried a magenta dev the fault remains. Also replaced the transfer roller
i have...
Strange fault , the machine copys fine when you print it comes out with magenta lines , file is fine as test on various other models back at office. Weirdly prints ok via the USB on the machine
...
Not Used FTP , but if you have a Fiery on there , use fiery scan and set it to drop the file into same folder
Hi
we have a strange one this machine had a c2255 code so we teplaced the color moter. Only for the machine to start throwing up c5102. This will reset for a while bit re occurs
today we have...
I have a strange fault appeared on print/copies outs all colours mixed up also on mono prints/copies
i have attached samples from internal prints
could it be HV? or are we looking at a PWB?
try dip sw 145 set to 02 helps with 99-01 process jams
I have just had a similar issue but was getting CE 301 when machine was rebooting. I replaced HDD no joy the same. I did a full data clear 3 times before it totally cleared down. But the MFD has...
Thanks Mick01
you were spot on put some electrical tape on drum units fault gone
Has one had the registration sensor out of the machine?
I have one were the Actuator is loose, i have realigned at present but i am unable to get the unit out. I removed all the front section as i...
Has anyone seen this issue , there is a background half way down the sheet, looks like a blade not cleaning but i have swapped drums and grids, i also swapped over the cyan & black developer units...
The actual pin. It the hollow type. Replaced with a solid one
Solved the Pin had split in the drive gear see attached pic gear 15 pin k
has anyone seen this issue
tray 1 is set to custom paper size, i can alter for individual job to say A4 paper feeds fine, but once the machine resets back to default it goes back to the custom...