Search:

All lines are cleaned off and all internal test prints come out without the lines.

Tested file in shop and had no lines.

Going out again tomorrow morning.

Wow still no help?

No thoughts?

Heading out this morning and will install fresh firmware I believe it is current but will reinstall.

This shows the lines on the transfer belt.
...

http://i299.photobucket.com/albums/mm292/mad0ram/IMG_3149_zpsbjkumsqn.jpeg


The lines are cross feed on trailing edge.
They are visible on the transfer belt but have never been able to see them...

Remove the back panel of the exit tray section of the finisher.
Remove the Up Down motor assembly. (hold the exit trays while doing this)
Lower the trays below the paper exit slot.
Install the Up...

Scanner home position sensor.

How many times have you got it most of the way back together, Looked down and saw a piece that needed to go in earlier.

Been there, Just chuckle at myself and start removing parts.

Look at page 2 of 2!

Thought there would be a little more input on this.

Went with the Veto XLT should be here next week some time I will give feed back when it comes.

I was looking at the Veto XLT.
By it self it weighs in at 10LB but looks like its built like a tank.


https://www.youtube.com/watch?v=DtdM9mdQ8Gc

What kind of bag do you guys carry?

Looking at a new one and need something a little more laptop friendly.

Check to make sure the static illuminators are not gummed up with junk stopping the paper from falling down completely.

Direct from Minolta.


19901

How did you check the print board??

After changing developer did you complete the required adjustments?

We need more information.

Yes.

Did you fuse the belt or put a new fuse in the old belt.

If you fused the belt make sure it was the correct fuse.

It is panel reset.

Unless everyone is signing out of the copier when thy leave or signing the previous operator out when they arrive they may as well turn that off.

10 minutes is a long time,...

By the way the kit worked wonders for my issue!!

Sorry about the Hi-Jack.

If there is no error code you will need to remove the drum and clean the toner control board sensors.

X2

And it's an easy place to start.

So the fix was to re-flash the copier? Or to replace all known parts?

I would feel a little sceptic leaving this machine.

All this should be done before any print has gone through the machine.
Access to maintenance mode is necessary.

10. After replacing the developers /Y, /M, /C and /K, conduct the
following items....

Try to re-flash firmware sounds like it thinks it is installed in a C-252

That is the worst belt damage I have ever seen If you do figure out what caused that let us know.

All units should be manufactured after that date by now.