I’m curious if anyone else has seen or has the part number for the updated Separation roller in these copiers. The original roller is part #303LL07190, but I’ve seen an updated Sep roller that has a...
Type: Posts; User: bdesire
I’m curious if anyone else has seen or has the part number for the updated Separation roller in these copiers. The original roller is part #303LL07190, but I’ve seen an updated Sep roller that has a...
Do you have a copy of the firmware? also do you have instructions for removing the laser unit? Thanks in advance.
08 4546 doesn’t do anything and neither does 05, 4720. The machine codes out before either of these. It looks as if the black has a faint line in however the developer and main charge unit has been...
I wish it were that easy but the customer has had it for 5 years and expects to get 10, and is willing to look up and buy all possible parts needed.
Thanks for all the replies, when I figure out the problem I will post it. The Black and Color maintenance kits have been installed with no change. The error code shows up immediately after the...
I need the Parts and Service manuals for this copier. Thanks in advance.
I don't have a copy of the firmware, I just want to make sure that I get the right firmware being this is the Oki version. Thanks for the reply.
Hello, I have the Oki version of these copiers and I'm stuck with a machine that will boot to ready to copy and then throw the CA00 code. So far I have cleaned the ID sensors beneath the transfer...
I need the Parts and Service manuals for the Savin 3406WD. I'm looking for the part number for the developing unit. Thanks in advance.
Hello, I'm looking for the parts manual for the SR 4130 finisher. I need the part number for the main side door, the actuator for the door switch is not replaceable on this door. Thanks in advance.
The MPC 3504, Thanks in advance.
Hello, I’m looking for the Service and Parts manual for this finisher. Thanks
The copier seems to notice the fax board on initial startup, the fax shows up in User Tools for two seconds and the disappears. That’s why I figured Firmware might help. I may need Firmware. Thanks
Hello, I have a MPC 3503 that is getting power to the Fax Board but will not show the Fax on the screen. I’m hoping that a firmware update will get the fax working again. Can anyone send me the...
Hello, I have a client that uses dot matrix paper for medical billing, these papers are four pages thick - the original page and three carbon copy sheets. The client would like to use a Kyocera MFP...
Sorry it took a few days to get back to the call. On different Android phones one will print and the other will give a system error 91. I have a S10 Plus with Android 10 and it works, meanwhile the...
Hello, I’m on an MPC3504 and Smart Device Connector will not print the last page if the document is three pages or more. Any special settings on the app or the copier? Any ideas? Thanks in advance. I...
Very little curl if any.
Long edge first in another tray works without issue. All feed pulleys for that cassette have been replaced.
Yes all OEM parts have been replaced. It's just uncommon maybe two or three out of a ream will be damaged.
Can I get a little more info on adjusting that guide. Thanks
The only tray that gives any trouble is the first tray which is letter long edge feed only. I ran it without the bridge and finisher with a small amount of wrinkling but no tear in the paper edge.
Yes I ran a fresh ream of paper, however I will go back with a different brand and see if it makes a difference.
Hello, I’m getting a small tear and wrinkling in one in maybe thirty or forty sheets of paper. So far I’ve replaced the heat sleeve, press roller, transfer roller assembly and drive unit for the feed...
I will check that out, Thanks for the info.