Todd is great to deal with and if you order over a certain amount you get a nice discount also!
Type: Posts; User: mmru4real
Todd is great to deal with and if you order over a certain amount you get a nice discount also!
Also with a fiery, you have to replace chips as the fiery will lockup with a very annoying message
Guys have searched near and far and cannot find,along with searching Canon's support page for this and the old internet. Any help would be appreciated. There is a number on the board Qm3-3120, but it...
More than likely it will not go back that far as it holds info for only the last 100 jobs.
http://www.copytechnet.com/forums/konica-minolta/70305-bizhub-c35-jamming-tray-2-only.html
Please see this thread.
we have used paper shim and wooden shim please see attached pics
Shim would go almost directly below power switch.
I concur didn't these have to have ps3 enabled and when they didn't they print gibberish
Have you tried memory experts they have them for 99.
The shim should be on the left side near the front corner between tray 2 and 3. I can post pictures next week, it has fixed every machine we have that has the additional tray
The shim should be on the left side near the front cornercorner between tray 2 and 3. I can post pictures next week, it has fixed every machine we have that has the additional tray
Put a shim between the 2 trays we have done this to everyone of our machines for the same issue and it resolved the problem on 12 machines.
It is a known issue and there is an foc replacement for the touch panel, but you have to call ssd first
C35s don't get lines of shame, since there is no setup, we have had several with main pwb issues and hv unit, I would tend to think it is with hv unit especially if someone previously removed it,...
There is actually a new foc sensor to address this exact issue just release in the past week.
Put a shim between the 2 trays we have done this to everyone of our machines for the same issue and it resolved the problem on 12 machines.
Home depot has a window shim kit, using wooden shims. We have found that these work the best. Konica will not acknowledge there is an issue though
Is this with the extra tray installed if it is, we use a shim on the front left corner and it has resolved the issue on 25 machines so far
Have seen this a couple times, usually it's because the transfer belt was not all the way in or screwed down before the door was shut, it's not a lot of fun to get it open afterwards
But even if they said you paid too much for the equipment it shouldn't matter because you are insuring for a certain amount, if the equipment was a total lost they should be paying the insured...
Can't believe no one is interested. I thought millions were jobless :)
The Only Protech dealer in Maryland, Washington, DC is currently seeking a Field Service Technician for our growing service department. This individual will service customers in Greater Baltimore...
Good Luck with your closing!!!
Copyprint there are several types of banner do you mean kms banner printing or what the industry and windows calls a built in separator page.
I always say the higher the degree, the stupider they are and life is hard, bit it's harder when your stupid.