Thanks for the manual, I have completed the fresh installation of the system software to the hard disk. And then set the software switches back to OFF. I still have an issue in that the LAN network...
Type: Posts; User: copylogic
Thanks for the manual, I have completed the fresh installation of the system software to the hard disk. And then set the software switches back to OFF. I still have an issue in that the LAN network...
Hi I have a IC 412, that was called in as cant print, the Bizhub C452 controller menu, shows " Please Wait" but never comes to ready. The Fiery IP address is fixed 172.126.1.5 but will not respond to...
Might be worth holding off till tomorrow when new SATA controller firmware becomes available
"Installing the special SATA Firmware GXX-*B0 will update the SATA controller and
prevent any future...
Hi
Is anyone aware of a report on Lexmark printers, cs748de, that records toner cartridge replacements
I am aware of toner coverage reports in Device statistics, but I am after a report that...
My understanding is that the firmware released this week will recover a machine that is currently in an error state ( displaying c code / will not accept firmware) the final fix to prevent machines...
Had a batch of C368 installed at site for 3 months running reliably, then 7 out of the 10 installed began to error with CD011 F114 some were recoverable some machines were not, The code points...
Had an interesting error on a 7551ci recently, The machine shows F041Communication error between Main PWB and Scanner engine, oddly the power supply for the scanner ISC PWB comes from the Power...
Hopefully you got yours running, I have attached the install manual for the
IWs tool 27700
mu issue is I have a 224e with the marketplace installed and running, I have then downloaded two...
Hi can you attach copies, most of the ghosting issues I saw on these machines was caused by the fan located next to the Bypass / mp tray being blocked with dust.
In our experience once you have ruled out the dev unit and the toner cartridge, it is often the Toner drive motor assembly, the motors still rotate but loose their torque so cannot turn when the...
Anyone still not getting this j4020 ,4220 we have seen so many now but not found the fix
Hi replace the dev unit, 2LH93034
Some of the original dev units shipped within the machine were assembled less accuratley than others.
Hi Guys,
Looking for an experienced engineer on either Kyocera or Konica for an imediate start. Area will be a choice of City, London, or North West London. Car, mobile, laptop etc. Good pay...
We have lots of these machines out and they are pretty good, I have been reliably informed that they have far fewer pickup jams J0501 if you remove the white clip, we tested it and its true.This is...
Try the auto gray adjust in system menu.
most likely to be a black dev tho seen it loads off times