Thanks will do the follow thru and update all.
Type: Posts; User: ldfrepairs
Thanks will do the follow thru and update all.
Replace ink bottle message keeps been displayed. Replace RF module. Worked for 1 week message came back. Any suggestion what could be causing the RF Module to fail?
Yes OEM toners. I did firmware update
I have 2 lexmark color printers that give me yellow back ground when printing color. I have replaced the transfer belt, yellow developer, photoconductor drum and HVT board but problem persist. any...
I did replace drum unit and perform the reset procedure but does not work.
Can anyone advised if there is a way to bypass the drum error for the brother hl2270? I performed the drum reset procedure but does not work.
Anyone have the illustration for the gears alignment for the ADF drive assembly?
The main drive assembly is what I am looking at now. have requested a quotation to purchase
The Unit I replaced is the FM4-7900.
Next step i guess will be to check the HV connections again and then replace the Fixing drive unit.
I eventually got to replace the complete fixing assembly. check nip width but still getting the Error code 000014 displayed. Any other suggestion would be greatly appreciated.
no generic. ink and master are OEM.
Came across an RZ220 displaying error codes D04-560 & D17-237.
Check the meaning of the codes and troubleshoot. Did not find any cut wires. Replace print cylinder with a working one but error...
Thanks will perform nip width test
The print drum is ok. I have not been able to pinpoint if its scan or master making issue cause its not consistent. will work fine for weeks or months then suddenly, issue appears. was checking if...
Please find attach samples. original and copy. copy is cut off at the bottom. any suggestion.
Thanks4470744708
I have replaced the fuser film, presssure roller and bearings and error occurs occasionally. I have tested fuser motor and it works properly. Any advice and next step.
Thanks
did you replace thermistor/stats?
No I did not replace any thermistor
did you replace any bushings/bearings?
yes replaced bushings
did you buy parts a reputable source?
yes, items were...
I have replaced the fuser film and presssure roller and error occurs occasionally. I have tested fuser motor and it works properly. Any advice and next step.
Thanks
Can anyone refer me to where I can buy a Cutter for an EZ220 Riso, besides PRNTNOW. Thanks
I have experienced the same issues. torn film and lines on dev sleeve. just replace film or fuser and dev assembly parts
Each time a master is cut error code P13-232 and A16-525 are displayed. Maser is cut and a test print is fed but not completely delivered due to the error. I have checked all aspects regarding...
Title : E520 sub code 8001
Error :The pick up roller will move towards the rear and start to vibrate, then the E520 is generated with the sub code 8001.
Workaround :
Replacing the offset motor...
Printed copies are grey instead of black and lines are slightly blurr. Has anyone come across such a situation:
Cannot remove toner cartridges. Cannot find section in Manual to remove main drive assembly to check what is causing this issue. Can anyone tell me what is the cause without having to remove main...