The ribbon cable to the op panel is probably loose.
Type: Posts; User: Has Been
The ribbon cable to the op panel is probably loose.
Unscented Baby Wipes
Dirty Magenta Charge roller
Set weekly timers to Sunday.....Off 2300 on 2303...should bring them back online.
Laser printers and copiers will not do envelopes or labels.. Have your boss buy them a thermal label maker.
Yes, getting more frequent.
There is a circuit board on the front of the machine. Check the connectors. I think its called Front PWB
Did you try sim 906?
Make sure that the transfer roller does not have broken springs and not contacting the drum.
Yep, it's the ribbon cable at the bottom of the op panel front, The cable is not secured well and vibrates loose.
Try sanding down the mag roller with Scotch Brite
Dear Customers,
Copiers will not do labels or envelopes.
Thank you for your business.
Unplug or stick a wad of electrical tape in the blades.
Stock up on internal finisher catch trays, very flimsy. If you look underneath there is a hole in between the attaching tabs; secure with self tapping screws. I don't like the fact that the tray...
Call the hotline and have them remote in and reset the printer.
A key is stuck down or you have a bad operation panel. Some times disassembly and cleaning of the unit will help.
Loose / defective DIMMS
Sim 617. Card must be mounted in the new machine when doing this.
These machines are tough as nails. I agree with your customer.
Has the small tab on front of the roller holder been broken off ?
Mark the mag roller to ensure that it is turning.
If it's a digital phone system, make sure there are no voice mail messages unanswered.
Pull the power source from the main board a couple of times to clean the pins.
I'll never understand why customers lie about toner cartridges...they ALL do it, even nuns and priests.
Check the micro switch that is tripped when you lift the tray into position, the actuator can get knocked off.