Have you ever found a fix for this?, we are having that issue on most 54 series with a thousand sheet finisher , one we had to replace with a 4000 sheet finisher to fix it. any help would be...
Type: Posts; User: Luther
Have you ever found a fix for this?, we are having that issue on most 54 series with a thousand sheet finisher , one we had to replace with a 4000 sheet finisher to fix it. any help would be...
Hi guys, can someone explain where on the finisher you are putting the washers and how thick they are?
did you run u130? when installing a new dv you need to run it
I would check for a bent pin in the side door connection on the machine side, it's easy to bend them and they may have been bent before you changed the conveyance section.
the spring stays on the drum unit, there is a metal clip that aligns with the spring when you put the charge roller back in
The blade comes out without removing the drum just remove the charge roller and you will see the 2 screws holding the blade in, the lamps should be cleaned right from the top of the drum unit, the...
Have you tried a new k developer unit?
It's more then likely going to be disabled when you get there, do a 906 and try the DP, if the plate does not lift or it codes again it's going to be the DP board , replaced 5 or 6 for the same issue
There is no spring in the 40ppm only the 50 and 60ppm both have the lift motor, agree with previous post to change the clutch pack
update the firmware to the latest, we sold a bunch of this model and they all eventually had that problem, firmware fixed them all
It's in the service manual beginning on page 4-4
Also make sure all service doors are closed
Sorry it was the pro8200ex, but it is rebadged as a Kyocera 13600, I replaced the DRB and the motor and all is good
I could use a little help with a code i am getting on this machine, sc 513-01, have very little experience with ricoh and just need a nudge in the general direction, have the manual but not clear if...
its not adding toner to the developer unit thats why when you install a new unit the code goes away, i would pull the main drive unit and back out all the drums nd dv units, behind the main drive is...
Also update the firmware when you replace the fuser, it changes some fuser timing to help with this problem
I would go with the HVT, I had the same issue but it was with all the colors except black same spacing of the image
I would try reseating all the connectors on the paper feed image board, then try the transfer board. those errors other then 7620 are density codes on the transfer belt for the color .7620 is only an...
SD-1GB 855D200754 1GB DDR3 Memory DIMM,SD-512MB 855D200753 512MB DDR3 Memory DIMM, these are the memory options for the M5526
It's the developer for sure, you may try a dv refresh and it may clean up, but eventually you're going to have to replace it
Hve the same issue on the PF-7110, just lube the pivot ponts, good tip !!
It belongs in the fuser, its the exit switch actuator
check the drum shield it may not be swinging out of the way, you can just remove it
I would check the worm gear on the tray lift motor, the gear may be worn but works going down but cant go up that may be the buzzing you hear. i have replaced quite a few
have you done a fuser reset? u163