Search:

Type: Posts; User: Woxner

Page 1 of 20 1 2 3 4

Search: Search took 0.30 seconds.

  1. Replies
    1
    Views
    140

    Re: Ruebilding developer unit in KM 654/754.

    they are all 400g. it should come that way if you buy the bottle.
  2. Replies
    6
    Views
    204

    Re: Konica c458 with http error 500 on screen

    error 500 is smtp error
  3. Replies
    10
    Views
    247

    Re: kmbhC764e firmware issue

    and no cant be turn off. clear the usb and just put the files in the folder on the drive. then it shoud work. will probably be about 400 files or so. just control a when highlighted just copy and...
  4. [Misc] Re: CHIRP CHIRP CHIRP noise when 1st motor starts , Biz 361

    you can test these motors under state confirme load ck. motors and sensors. its in the manual. i always use this to test toner sensors and motors
  5. Replies
    5
    Views
    270

    [Misc] Re: Bizhub C754e thinks it's a Generic 60C-6E

    setting wrong machine type will do this too. i have replaced boards and it does this. never had to set sw 10 but if it works good to know
  6. Replies
    8
    Views
    535

    Re: bizhub 808 with scanning issue

    make sure the machine type is correct according to resolution. here is something else too


    Check and clean the CCD sensor. Check and reseat connector CN3 on the CCD board (CCDB). Next, check the...
  7. Replies
    11
    Views
    663

    Re: KNBH C754e log in screen

    if they were using card readers in service mode hit stop 9 or stop 0 c. this will get you in to turn it off. could be stop 0 9
  8. Replies
    10
    Views
    443

    [Misc] Re: DR-012 Humidity problem

    make sure all your filters are clear so air flows. may need a dehumidifier. rains alot in florida but dont really have that problem.
  9. Replies
    4
    Views
    315

    Re: Konica Minolta Bizhub C284 Service mode

    there is a reset firmware tool you could use. it is use to reset a board that is not been cleaned and you need to use that pwb
  10. Thread: Biz 25e

    by Woxner
    Replies
    12
    Views
    486

    Re: Biz 25e

    not that i know of
  11. Re: C364e won't scan to email but emails status & counters ok

    is it saying derver connection error login error. also what is firmwre . if all else fails if this is a used machine you might need to do a data clear. but back everything up first. network clear...
  12. Replies
    12
    Views
    662

    Re: Bizhub 601 Developer Change

    you just need to run the Drum Peculiarity steps. do all of them . drum goes 500k if its due replace it too.
  13. Replies
    7
    Views
    378

    Re: Bizhub Pro c6500

    these cost an arm and a leg to service. it you arent trained stay away. these are old . support was discontinued in 06/2016
  14. Re: Kip 700M will not purge queue thus printing multiples of a single sheet job

    IPS may need to be re imaged. use the disks. using the control panel does really do the job. back things up first
  15. Replies
    14
    Views
    498

    [Dead] Re: BizHub C250 won't print, led data blinking

    are you using authentication or account track? if so the code needs to be entered in the driver. but mfp would be next.
  16. Replies
    5
    Views
    582

    Re: Kip 7170K E2304 errors

    looks like transfer corona is bad. is there codes in the history? i have machines with 500 to 700 k never done pm kit. one dev rebuild.
  17. Replies
    10
    Views
    1,317

    Re: KM Firmware naming

    one thing about firmware is there are fixes that are not listed in the list of fixes. i had problems with a hospital program they use. turns out special firmware fixed it. but this was not listed. i...
  18. Re: W10-64 bit doesn't like the BH-C-360 v3.7.0.0 driver?

    just install it the old fashion way and not using the program. dont use universal driver they are crap and you dont get all the features
  19. Re: Bizhub 227 does not print until it receives the whole file

    dont use universal driver they suck... also try and set in network of machine under details the speed set to 1GB its helped my on this.
  20. Thread: Swapping boards

    by Woxner
    Replies
    4
    Views
    2,433

    Re: Swapping boards

    they are tied to the machine. you can get a new bd and do diag and it will not marry the machine. i was told bd from another machine may not work
  21. Thread: service SMTP

    by Woxner
    Replies
    12
    Views
    1,480

    Re: service SMTP

    i used to use scheduling. you can set it to send email. i have also use vcare to send to the company i was at.
  22. Replies
    6
    Views
    2,230

    Re: Duplicators vs. MFP's?

    copy quility is night and day. MFP's are very cheap on cost. plus you get tons more options on mfp.
  23. Replies
    19
    Views
    2,178

    [CQ] Re: 8 series drum life

    pretty much advertise yield . once in awhile you get lucky and it goes longer
  24. Replies
    14
    Views
    1,594

    [Error Code] Re: Bizhub C280 error C2554

    should mention you should change the drum too or it might pull again
  25. Replies
    14
    Views
    1,594

    [Error Code] Re: Bizhub C280 error C2554

    if the cyan is banding from depletion you will need to change both. i have seen these pull even if life has not been met.
Results 1 to 25 of 488
Page 1 of 20 1 2 3 4