Thanks:
0
Likes:
0
Dislikes:
0
-
Technician
- Rep Power
- 0
error 010-321
How i Fix Error Code 010-321 In xerox DC250
-
Trusted Tech
50+ Posts
- Rep Power
- 37
Re: error 010-321
010-321 RAP
BSD-ON:10.1 Fuser Drive Control BSD
Fuser Nip Fail.
Initial Actions
• Power machine Off then On to see if fault clears.
• Check if the Drawer is pushed in with the Fuser Unit improperly seated before the power
is turned on.
• Check that there is no paper wrapped around the roller/s.
Procedure
Check that the Fuser Nip Sensor actuator is properly installed and not damaged. The actuator
is properly installed and not damaged.
Y N
• Re-install the actuator properly.
• Repair/replace the Fuser Nip Sensor (PL 8.1).
Enter dC330 (010-203 Fuser Nip Sensor). Actuate the Fuser Nip Sensor by moving the actuator
manually, then release the actuator. The display changes.
Y N
Replace the Fuser Nip Sensor (PL 8.1).
Replace the MCU PWB (PL 11.1).
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks