Good morning I was hoping that someone might help me with a code L4-16 on my Sharp MX C311, is there any way to reset this code or what it means and what I can do?
Thank you so much,
Glen Bennett
Good morning I was hoping that someone might help me with a code L4-16 on my Sharp MX C311, is there any way to reset this code or what it means and what I can do?
Thank you so much,
Glen Bennett
Fusing pressure release trouble
A change in the fusing pressure release sensor signal cannot be detected within the specified time afteroutputting the fusing pressure release motor.Fusing pressure release sensor trouble.Fusing pressure release motor trouble.Pressure release drive gear and pressure release idle gear trouble.PCU PWB trouble.
Connection trouble of the connector and the harness
Replace the fusing pressure release sensor.
Replace the fusing pressure release motor.
Replace the pressure release drive gear and the
pressure release idle gear.
Replace the PCU PWB.
Check connection of the connector and the harness.
Hi
try to reset with sim-14
If the trouble code doesn't clear with SIM 14, then the pressure flag is most likely broken. Sharp has updated this part multiple times. The current part # should be MLEVP1112FCA4
Or replace the whole fusing unit.
i would go with the gear being broken. i have done that a lot
Broken flag PN MLEVP1112FCA4, the newest part number that I'm aware of (not that it resolved the heat damage issue either...).
Ive been fighting this issue too. Without ordering a new fuser. Check the solenoid, lock lever, and one way bearing on the pressure release lever and shaft. Good luck.
This has happened to me once. Would check for a unicorn in the ADF.
It didn't say that I couldn't do it in the manual.
Bookmarks