Likes:
0
Dislikes:
0
-
Doc feed Problems MX-3115N
Having an issue with the ADF on this machine. It dose not recognize that there is paper in the ADF I removed the back panel where the ADF plugs in to the machine and the back side of the feeder, when I unplug the wires from the back of the machine and plug them back in it will work for about a minute same thing if I do it to the wires on the feeder itself. Haven't done much else to it beside just clean up connectors and sensors as this was one of those "Oh yeah this dose not work either" situations and had to get to my other calls first. So just seeing if anybody ran into this before or has any other ideas before i go back. Thanks
-
Senior Tech
100+ Posts
- Rep Power
- 30
Re: Doc feed Problems MX-3115N
I presume that you 've try sim 2-2 to test the switchs when the issue occurs,
-
Re: Doc feed Problems MX-3115N
Yeah I figured this one out it was the sensor that was going bad replaced it and its been fine since. paper detection sensor VHPGP1S73P+-18
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks