Sharp AR153E Error Blinking Message H3

[blacktriangle]

Guys and Gals,

How can i rectify the error in the AR153E Copier with Error blinking message H3.

Thanks

[NCArt]

The H3 message is for an abnormally high fusing temperature. The thermistor has probably built up with toner and is giving bad readings. Try resetting the code first, then clean the thermistor.

[mtech]

How many copies on the fuser? It may be time to replace it. Check thermistors and lamp and thermostat.

[blacktriangle]

The H3 message is for an abnormally high fusing temperature. The thermistor has probably built up with toner and is giving bad readings. Try resetting the code first, then clean the thermistor.

bro, where this part located? do i have to disassemble the plastic or i can hardly reach by removing toner?

Thanks

[blackcat4866]

Now would be a great time to open the phone book and dial up your local copier professional. If you don't know what the fuser looks like, you're going to need more help than we can provide here.

[manuals4you]

But if he had the manual even a monkey could prolly figure it out.

Paul@justmanuals.com

[NCArt]

bro, where this part located? do i have to disassemble the plastic or i can hardly reach by removing toner?

Thanks

If you have to ask that, might I suggest you find a qualifed technician.

[repair.code]

Chang Heater Lamp
Good Luck

[johnbla]

Chang Heater Lamp
Good Luck

you a Salesman or a Tech...??


If it's getting too hot ~ H3-00, then the Heater Lamp inside the Fuser is working fine....but the Termistors, which control the Temp/Lamp are not....

Think before you post.