MX-C401 double imaging/ ghosting

[Greyson]

Most likely, based off what you have said, you need to replace the hot roller. The second thing that can cause this is the Blade that cleans the drum. If its not scraping off the toner it will leave the double image. Least likely would be drum needs to be replaced.

I would start with the drum Unit not very costly. MX-C40NRB

[techwurk]

If not the fuser, then toner suspect.. inspect all of the drum cl blades or transfer belt for signs too

[nottoosharp]

Does this unit have a cleaning web?


Sent from my iPhone using Tapatalk

[Aaronhauck]

"FIXED"

I fixed it with replacing the developer like i said in my last post. I replaced the fuser 2 times thinking it was defective and not putting the right pressure. I thought it was pressure because i can see the image on the upper heat roller and it would not clean. The fuser does not have a cleaning web. I had checked the drum and bl / TC1 belt and blade but this problem was in the fuser not cleaning. The developer was bad and wasn't fusing properly. That's a first for me. Thank you everyone for all the help and feed back.

Aaron