The scanner only moves during simulations 1-3 and 1-4, it does not move when I try to make a copy.
During simulations 1-3 and 1-4 the scanner assembly moves back and forth smoothly, through it's full travel, without any undue resistance. Likewise simulations 1-2, 5-3, 5-1, 5-2, 5-4, 5-5 and 6-2 all complete satisfactorily.
When I run simulation 1-2 with the scanner assembly in the home position both the OPC drum lamp and the Toner Empty lamp come on.
When I manually move the scanner assembly away from it's home position and then run simulation 1-2 the OPC Drum lamp stays on and the Toner Empty lamp goes out.
Thanks for responding you-all.
I am actually starting to think that I might get this going.
Regards,
Pilgrim
Bookmarks