I have a sharp copier mx-5140 which after powering on displays "call for service f2-41. Help resolve this problem.
I have a sharp copier mx-5140 which after powering on displays "call for service f2-41. Help resolve this problem.
Have a look at the Cyan developer unit. I've had these codes in the past where the machine has dumped the developer.
I see these F2 codes usually when generic toner is used after a SHARP brand toner was used prior. "F2-40 BK, F2-41 Cyan, F2-42, Magenta, F2-43 Yellow. " Bring spare color DV with you and if you can't clear the code replace the DV and install a new toner. The toner density sensor could be bad but usually in my experience it's not the most common. Good luck.
1. check to make sure that toner density sensor on dv box is clean and not cracked, replace if neccassary. 2. Check to make sure that drum is not scratched from either drum seals out of place or dv box side seals out of place. If either one or two has happened you will not only have to replace dv but all three dv's and drums. Dv will usually puul from drum being scratched so check drum first. regardless if you change one color you have to change them all.
Bookmarks