Looking for the main board for this finisher. My finisher is dead. Thanks
Looking for the main board for this finisher. My finisher is dead. Thanks
I just a code F1-00 saying that the finisher communication error. When the machine turns on nothing from the finisher just a code. thanks for any help.
"You can't trust your eyes, if your mind is out of focus" --
Thanks. I tried that and on 2 different machines. Checked the fuse on board on the finisher and it checked out good. Thanks
I have had this before and the issue was the actuator and sensor for the upper tray home position.
If you move the sensor so it is triggered just a little better by the actuator this will correct your problem, or the actuator could be broken.
I have seen a broken wire in the interface harness from the copier to the finisher. I suggest to check your continuity for the harness wires.
Like Zootech said, with power off and machine unplugged check the connector at the copier side, remove the back cover to be positive you have a full connection. The frame there is very thin and easily
bent. I had this before with that f1-00 and that was the reason.
When I started servicing copiers they used toaster ovens for fusers.....I'm old
Bookmarks