MX3610 Calibration fault

[woko]

Hello All, I have a MX3610 that won't calibrate SC 64/74 I put the print on the glass the machine scans then just says put the chart on the glass? machine copies fine and prints ok however the colours are not right as it won't calibrate.
any ideas??

all the best Woko

[dwarf]

SC 46-74...if the machine scans but won't produce the next page for calibration, I believe you have placed the copy down incorrectly on the platen..the little black orientation line must be all the way to the left...

[JLSam]

SC 46-74...if the machine scans but won't produce the next page for calibration, I believe you have placed the copy down incorrectly on the platen..the little black orientation line must be all the way to the left...

Second Dwarfs comment.

[woko]

SC 46-74...if the machine scans but won't produce the next page for calibration, I believe you have placed the copy down incorrectly on the platen..the little black orientation line must be all the way to the left...

thanks I know about that and what ever way you have the sheet it won't calibrate

[dwarf]

lots to consider...try firmware...not sure if a sim card is in it...use several sheets to back up the test sheet...or you may have a bad board...

[woko]

lots to consider...try firmware...not sure if a sim card is in it...use several sheets to back up the test sheet...or you may have a bad board...

I have now been able to reset the calibration setting to factory default with sc 67/31 so the copy quality is no OK, will post if I find out what's caused this problem.
Woko

[austonrush]

Try Sim 50-28 first

First run BK-MAG Adjust and then run SETUP/PRINT Adjust, restart and try again. The issue is the copier sees the chart but, it cannot read it as your out of calibration.

This will almost always solve this specific problem.

As to your colour requirements you can also try changing SIM 63-11 to def 1 from def 2. You must calibrate after you make any adjustments here.

cheers

[Phil B.]

you did clean the optics before trying the calibration correct? I have seen techs waste time on trying to calibrate with out cleaning the optics first.

[woko]

Try Sim 50-28 first

First run BK-MAG Adjust and then run SETUP/PRINT Adjust, restart and try again. The issue is the copier sees the chart but, it cannot read it as your out of calibration.

This will almost always solve this specific problem.

As to your colour requirements you can also try changing SIM 63-11 to def 1 from def 2. You must calibrate after you make any adjustments here.

cheers

Thanks I will try this and let you know, the machine is a stock machine that's in my workshop so I will drag it out and see

[austonrush]

Thanks I will try this and let you know, the machine is a stock machine that's in my workshop so I will drag it out and see

Great, let us know if it works!