I got the water mark to down load. I go to 49 then to water mark. touch display but for some reason it wont black out to start down load. Do I need to hit the dip switch on main board. I did extract the file. any thoughts would be helpful. Thanks
I got the water mark to down load. I go to 49 then to water mark. touch display but for some reason it wont black out to start down load. Do I need to hit the dip switch on main board. I did extract the file. any thoughts would be helpful. Thanks
Does the touch panel show the file on your USB drive?
All Sharp files from a USB must be no deeper then 1 level. If the file is in a folder INSIDE another folder, it will not see it.
In this scenario, it will usually display two dots.
Also, Sharp is notorious for hiding a .zip file inside of a .zip file download; you will need to double extract.
Failing to plan is planning to fail!!!
Also make sure the USB drive you're using for firmware updates is formatted as FAT32. The Sharp cannot see NTFS formatting.
I have tried everthing. Still noting. Extracted it. display just shows but the file but wont black out. Think im missing a step here. Has any one done this on this model and can I get the step to doing it. Thanks
Page 9-6 in the service manual details step by step instructions for the installation of the watermark firmware.
The Moose is loose!!
I just did a HDD wipe on a 6240 Friday.
When I downloaded the watermark, it was zipped. I extracted it, and THE EXTRACTED FILE WAS ZIPPED. I had to unzip a second time, move to jump drive, then SIM 49 worked fine.
I downloaded the model you are referring to and yes, it is double compressed. See below:
Capture.jpg
Failing to plan is planning to fail!!!
Bookmarks