How to ignore error C4-02?

[jonathan3205]

Hi, I have an MX-5001N Showing the error C4-02. I already order the replacement part, but it wont arrive till the next week. The manual says that you can temporally override this error by changing some settings in SIM55-1
So my question is, how is it done?
I enter Simmulation mode
Then 55
Then 1
And here is where im in doubt
This is the screen that appears

000.jpg
Where it says SW I pres 8, and the this appears, is this where I putt the 1 or what? Isnt this suppoused to be 0? Why is in the 6?
rsz_dsc_0002.jpg

If you could provide any help I would appreciate it very much.

[dsmith46]

The manual states "SW 8-3 in Sim 55-1 to "1." What this means, you will change Bit 3 to a "1," of softswitch 8.

Go to Sim 55-1
Enter in "8" then hit softswitch
Change Bit 3 to a "1" instead of a "0."

Leave bit 6 alone if it is already a "1." There are hundreds of softswitches and 8 bits per switch. Each one relates to something else in the machine.

Hope this helps!

Good luck!

[jonathan3205]

The manual states "SW 8-3 in Sim 55-1 to "1." What this means, you will change Bit 3 to a "1," of softswitch 8.

Go to Sim 55-1
Enter in "8" then hit softswitch
Change Bit 3 to a "1" instead of a "0."

Leave bit 6 alone if it is already a "1." There are hundreds of softswitches and 8 bits per switch. Each one relates to something else in the machine.

Hope this helps!

Good luck!

Wow, thank you very much. This solved the issue, now I just have wait untill the replacement arrives.

Thanks for your help