Sharp Mx-m264n blank streaks across scans and prints.

[dwarf]

empty out the developer and check it for contamination... then run something small and flexible (small plastic ruler perhaps) through the gap between the mag roller and the doctor blade...vacuum thoroughly... at times I've found small chunks of foam floating in the developer...

[Ratchet2501]

Outside shot, but make sure you look at the transfer roller also?

empty out the developer and check it for contamination... then run something small and flexible (small plastic ruler perhaps) through the gap between the mag roller and the doctor blade...vacuum thoroughly... at times I've found small chunks of foam floating in the developer...

The transfer roller from the mx-311ka? Swapped that because it seemed to be squeaking. Im headed there this morning. Going to try cleaning the MC and checking the housing and connections on the developer unit. Update to follow. As always thanks for the ideas/pointers.

[dsmith46]

Are the streaks always in the same spot on the paper? If so, I would check the condition of the fuser. I have seen several of these when the rollers get worn out, they no longer fuse toner. I kind of skimmed through the posts, so I apologize if this has already been mentioned.