Apologies, I didn't even think to attach a diagram. *facedesk*
In sim 30-1 switch 1 should not be highlighted mine is on.in a working machine in that sim if you put 1 piece of paper over switch it gets highlighted.take out 1 piece of paper highlight goes out.What is so confusing is that when you make copy from working machine it never says remove paper from center tray.If you make over 500 copies which nobody ever does machine clicks tells you to remove paper from center tray not the sensor.this center tray switch 3 wires goes back to pcu pwb .Have board ordered.just when you think you’ve seen everything.......what a headache.
Make sure dilivery sensor (the sensor all the paper that has exited the machine sensor which sits in belly with all exited paper on top of it is working and is the correct one. Found out the hard way that the mxm 260 sensor was put on this after sorter was taken off 264.hope it helps Dave
Check sim 26-1 to see if some one has turned on the job seperator option this will give you that message if it is on and no seperator tray is installed.
Bookmarks