ok...
I arrived at the site... plugged in the copier... and it gets to the sharp screen... then it reboots...
unable to install firmware... it keeps rebooting...
disconnected fax and network cables...
I disconnected the fax board and the adf...
it made no difference...
I changed the ac pwb... no difference...
I disconnected the hard drive...
no difference...
I am looking into replacing the dc power supply, then the ac monitor pwb, then the hv pwb...
I am checking if this is the right order or if there is a better way...
the service manual confuses me...
any guidance to this knuckle dragger screw turner would be helpful...
Bookmarks