F2-78 MXM565

**RascalMJ** · 02-16-2018

Originally Posted by spanky

See attached

Man....y'all are good!!!!

I need to get better at searching the sharp website for bulletins....etc.

THANKS

Sent from my XT1650 using Tapatalk

**RascalMJ** · 02-21-2018

Originally Posted by spanky

See attached

We tried the humidity sensor with no luck.

Just received the countermeasure shielding and will try that asap. Question though. Should we look into replacing the imagine density sensor, or a good cleaning is ok? Also would it be advised to replace the DV as this error has been ongoing and could have effected "the mix"?

**tmaged** · 07-08-2019

I have a MX-M465N that we're fighting this code on. We've replaced the supplies, Cleaning web & entire transfer unit that has the new sensor in it. Also have updated firmware that addressed the code when coming out of sleep mode. Any other things that you've fixed it with ? Is the temp/humidity related to this code ? We have not tried that. Thanks for any input !

**RascalMJ** · 07-08-2019

Originally Posted by tmaged

I have a MX-M465N that we're fighting this code on. We've replaced the supplies, Cleaning web & entire transfer unit that has the new sensor in it. Also have updated firmware that addressed the code when coming out of sleep mode. Any other things that you've fixed it with ? Is the temp/humidity related to this code ? We have not tried that. Thanks for any input !

I believe ours ended up being related to a poor connection between the right side door and the machine. The connector was not lining up properly. Too some work and reforming the Earth spring {metal spring\plate}