MX6240

[woko]

Hello fellow tech's, I have had a dead MX6240 in my workshop for the last couple of weeks waiting for a new DC power board (sub), it arrived today and I fitted it, with great pride I told the boss the machine was now fixed, however when I went into sim mode the machine locked up, after switching off and on the machine will not go passed the please wait screen,

thanks in advance Woko.
IMG_0217.jpgIMG_0217.jpg

[Ratchet2501]

Machine we we're discussing on here earlier had similar issues due to the seating of one of the connections. Might try that route

[Paulm]

Try SD card. Classic symptom.

[mojorolla]

Unplug the HDD and see if you can get E7-03 error. If so, HDD is bad. Sharps boot MFP pwb, SD, then HDD.....

[woko]

Thanks for help folk, the machine has been put to one side at the moment, so will update as soon as I get the machine back in the workshop.

Woko