I have a mx-3100 that will self print fine but a plain old copy will come out with lines and distortions as though there is dirt on the spf glass or mirrors. Both of which are clean. All the usuals have been checked mechanically. I tried running a 66-10 to clear the memory but that didn't seem to make it go away. One thing I think might be correlated is the customer every time it would get stuck on a print job (vpn '>.> ) when you go to clear the job it pretty much gets stuck and takes an excessive amount of time to clear which they were shutting it down via the power switch instead of the power button up top. My thoughts are memory corruption, which I just happen to have a 2600 in the shop for scrap but dont think I can just swap the memory on one of these same family or not.
Bookmarks