Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 26
Mx-fn11/19 finisher issue
I have problem with a fn19 finisher installed on a 7580, the issue is when they staple or offset sets of copies it will intermittently fold a sheet over as it's being feed out but hasn't reversed into the staging area, has anyone seen this before? I cannot figure out what is causing it, my guess is it's hanging up on something but can't find anything in there's no blemishes on the paper lead Edge. Thanks in advance.
-
Re: Mx-fn11/19 finisher issue
Hi try
A. Basic adjustments(1) Upper curl mode in the service manual.
Good luck
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks