I am new to this machine, but I'm going in to replace the Developer and Drum Units. I need to know how to reset the "Maintenance Required" indicator on the panel, after I'm through. I assume, like most Sharps that there is no Developer calibration?
thanks
OC
To reset the maint counters, use SIM 24; DV calibration is with SIM 25-2.Originally Posted by Oystercopy
"You can't trust your eyes, if your mind is out of focus" --
Developer calibration 25-2, but leave the left door open after you change the developer and install developing unit. Enter sim 25-2 execute close door and wait for sim to finish, CA twice and you should be good to go. Sim 24 to clear counts. The reason to leave the door open is to prevent the MFP from adding unwanted toner before sim.
Posting Permissions
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks