Thanks:
0
Dislikes:
0
-
Technician
- Rep Power
- 14
Full Bleed Stripes 3570
I peeled one of these bad boys off my customer's fusing unit. They had 2 or 3 samples but I wasn't able to duplicate it. Print not copy. The pattern and variety of colors make no sense to me. Perhaps high voltage board? Anyone seen this?
Thanks in advance.
Uploads are failing on this site so here is a link
fullbleed — imgbb.com
Last edited by OperatorError; 06-01-2018 at 03:41 AM.
Reason: additional info, typo
-
Re: Full Bleed Stripes 3570
I always start at AC voltage from the wall and work to the copier, check ac wall voltage and check for proper ground.
-
Re: Full Bleed Stripes 3570
Wow.... can't wait to see the answer to this one.
Is this striping pattern continuous on the primary transfer belt?
Does a BW copy/print come out OK?
-
Re: Full Bleed Stripes 3570
Just re-read post......problem is not consistent.
Are all the samples provided by customer a result of a jam? Or do any of them exit?
-
Technician
- Rep Power
- 14
Re: Full Bleed Stripes 3570
The picture is one that exited. I think 3 exited and one wrapped around the fuser. When i arrived the stripes were on the belt but cleaned off when I ran it and could no longer duplicate.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks