Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 18
MX-M753N POD_N1
I have a 753 that is jamming every 70 to 80 copies. only seems to happen when doing multiple copies ( Larger Runs) page stops before fuser and has a fold in it with corners bent. Fuser drive unit doesn't look bad but I have one on order. It reminds me of the jams you get on MX-5100s that have a broken transfer belt Gear. Any suggestions are appreciated. It is a pretty long dive so I'd like to be ready for most probable possibilities.
Thanks
-
Re: MX-M753N POD_N1
The drive unit should take care of it. Thats a common problem with that model. There is a bulletin for it.
-
Re: MX-M753N POD_N1
TT-121313_3 Pod 1 and 2 jams.pdf
You're on the right track, I hope this helps.
-
Senior Tech
100+ Posts
- Rep Power
- 18
Re: MX-M753N POD_N1
I always like to leave a final outcome when I post on this Forum.
I ordered the fuser drive unit and installed it yesterday.
Ran 100 copies jammed at about 87 exactly like it did before same folds same dogears.
I then replaced the Fuser unit and ran over 100 with no issues.
I guess I will hear from customer if issue continues ( I hate intermittant problems)
Thanks for all of the responses
Last edited by xring1958; 09-26-2018 at 09:34 PM.
-
Re: MX-M753N POD_N1
The only dog earring I've seen is when the exit guide ribs on the fuser cake up with toner causing jamming and dog ears. Just clean off the ribs and problem should be resolved.
-
Junior Member
- Rep Power
- 0
Re: MX-M753N POD_N1
Had a similar scenario on one of our machines intermittent duplex jams (POD1) tried the drive/fuser rebuild/transfer with no success, replaced the fuser unit and the fault was resolved
hope you get the same result mate
all the best
Yorky
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks