Thanks Thanks:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4
  1. #1
    Senior Tech 100+ Posts
    Join Date
    Jun 2007
    Posts
    101
    Rep Power
    0

    Sharp MX-B401 fuser seating problem

    Just replaced the fuser heat roller gear, bearings, actuator, the roller cam that cracks, along with the 2 gears that are on a swingback assembly inside the machine cavity just above the fuser. Now that its all complete went to install the fuser and the side with the heat roller drive gear that's suppose to mesh up with the swing back gears won't allow me to seat properly on that side. Its like the swing back gears won't lift up high enough
    or something else is blocking the fuser to seat in place properly. Can't see anything in the way. Need some suggestions.

  2. #2
    Senior member of CRS 2,500+ Posts
    Sharp MX-B401 fuser seating problem

    ZOOTECH's Avatar
    Join Date
    Jul 2007
    Location
    Insane Diego, CA
    Posts
    3,093
    Rep Power
    86

    Re: Sharp MX-B401 fuser seating problem

    Quote Originally Posted by Will View Post
    Just replaced the fuser heat roller gear, bearings, actuator, the roller cam that cracks, along with the 2 gears that are on a swingback assembly inside the machine cavity just above the fuser. Now that its all complete went to install the fuser and the side with the heat roller drive gear that's suppose to mesh up with the swing back gears won't allow me to seat properly on that side. Its like the swing back gears won't lift up high enough
    or something else is blocking the fuser to seat in place properly. Can't see anything in the way. Need some suggestions.
    A lot of the return springs for the fuser drive do not get replaced, it may take some finess to install fuser unit. You might try a spring hook, or small flat blade to hold up drive gears to install.
    "You can't trust your eyes, if your mind is out of focus" --

  3. #3
    Senior Tech 100+ Posts
    Join Date
    Jun 2007
    Posts
    101
    Rep Power
    0

    Re: Sharp MX-B401 fuser seating problem

    Already tried that with no success.

  4. #4
    Senior Tech 250+ Posts harleyrider's Avatar
    Join Date
    Oct 2011
    Location
    ,il
    Posts
    344
    Rep Power
    20

    Re: Sharp MX-B401 fuser seating problem

    that "swing plate" probably isn't installed right. There is a little tab that sticks out and of the plate and it needs to be installed so that the swing plate will raise up to allow the fuser to go in. Hard to describe but if you look close you will see it.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here