Mx3110 vibrating noise

[ash_572]

Hi everyone. I have a mx3110 colour machine that’s making a vibrating noise. The vibration is nailing an impact on the colour copies with white lines in the image.

Black and white prints are perfect.

i have change the yellow and magenta dev units. All drum units have been rebuilt with drum kits. All drum units and dev unit turn perfectly fine by hand.

i have also replaced the main drive unit but still the same.

transfer belt and blade is also replaced and turning fine by hand.

i did transfer load in sims mode and tricked the front cover to see. Mainly the yellow and magenta dev/drum units are vibrating even though it’s been replaced. Very bizarre

any help appreciated.

[driving lots of miles]

It acts like a gear on the drive unit is missing a tooth

[ash_572]

It acts like a gear on the drive unit is missing a tooth

I have already replaced the main drive unit. Thanks

[JLSam]

Pictures would get you better responses.

Have you tried print stop test? Does the image quality problem happen during transfer? Or image creation?

Hows the LSU?


Sent from my ONEPLUS A5000 using Tapatalk

[ash_572]

Pictures would get you better responses.

Have you tried print stop test? Does the image quality problem happen during transfer? Or image creation?

Hows the LSU?


Sent from my ONEPLUS A5000 using Tapatalk

Uploaded picture

[repn1999]

did you use oem drums and mk kits? check the little gear on the back of the drum unit, and make sure the little tit is not broken on them. also check the transfer belt gear and drive gear to make sure the pins in them are not broken off.