Hi, i work mainly on Ricoh. i need to know if is it there a problem with just reseting maintenance or not. Asking for maintenance at 50k. Thanks
Hi, i work mainly on Ricoh. i need to know if is it there a problem with just reseting maintenance or not. Asking for maintenance at 50k. Thanks
The only problem on these occurs if the drum gets worn down to bare in any spot. You'll get light streaks from front to rear from voltage leaking. If the drum looks good, you should be fine.
A basic PM is drum, blade, developer, and fuser felt.
For service mode: #, interrupt, 0, interrupt
Sim 25-2 for developer stir
Sim 24-7 to reset drum light
Sim 42-1 to reset developer count
Sim 20-1 to reset maintenance light
Quick & easy. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks