I know it is in the polygon motor area. I want to know if anyone else has had this code and what was the fix.
Thank you for your help!!!
David
I know it is in the polygon motor area. I want to know if anyone else has had this code and what was the fix.
Thank you for your help!!!
David
Only two defining forces have ever offered to die for you:
1. Jesus Christ
2. The American G. I.
One died for your soul, the other for your freedom.
New p/n for just the polygon motor is RMOTN0022QSPZ. It is a lot less expensive to replaced just the motor, but it is a gamble that the motor was not causing the error.
"You can't trust your eyes, if your mind is out of focus" --
No mystery here. Replace the laser assembly. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
ZOOTECH - Thank you for your information. I thought it would be the motor but wanted other ideas.
David
Only two defining forces have ever offered to die for you:
1. Jesus Christ
2. The American G. I.
One died for your soul, the other for your freedom.
blackcat4866 - Thank you for your input!!
David
Only two defining forces have ever offered to die for you:
1. Jesus Christ
2. The American G. I.
One died for your soul, the other for your freedom.
never heard of someoane to fix this kind motor, u can only delay it in some cases, i heard of it hapend at Minolta too, and Ricoh/Lanier 5218 have same motor like Sharp ar5316 i've tryied that
at this series at about 300k poligonal motor is droping
FIX - Replaced the Laser Assembly.
Thanks to everyone for their input.
David
Only two defining forces have ever offered to die for you:
1. Jesus Christ
2. The American G. I.
One died for your soul, the other for your freedom.
Bookmarks